Some of our readers reported that they could only upload code when the ESP32 was powered with 5V. One of our readers reported the following: “ found out that you can program the board with a USB-to-TTL module model CP2102 and that the CH340 model does NOT work“. Also, check that you have the FTDI programmer jumper cap set to 5V. You should also press the on-board Reset button to restart your ESP32 in flashing mode. Important: if you can’t upload the code, double-check that GPIO 0 is connected to GND and that you selected the right settings in the Tools menu. Failed to connect to ESP32: Timed out waiting for packet headerĤ) When you start to see these dots on the debugging window as shown below, press the ESP32-CAM on-board RST button.Īfter a few seconds, the code should be successfully uploaded to your board. esp_camera_fb_get(): Failed to get the frame on time!ġ.No IP Address in Arduino IDE Serial Monitor.Psram error: GPIO isr service is not installed.Board at COMX is not available – COM Port Not Selected.Sketch too big error – Wrong partition scheme selected.Brownout detector or Guru meditation error.Camera init failed with error 0x20001 or similar.Failed to connect to ESP32: Timed out waiting for packet header.
If you have a different problem or a different solution to these issues, you can share your tips by writing a comment below. However, we’ve gathered all the information given by our readers to get answers to the most common issues. Please note that we couldn’t reproduce some of the errors on our end. We’ve modified some lines on the code, so most of the problems related with that project should be fixed. Note: some of our readers reported errors when trying to follow the ESP32-CAM project with Home Assistant. Take Photo, Save to SPIFFS and Display in Web Server.ESP32 IP CAM – Video Streaming (Home Assistant and Node-RED).Video Streaming, Face Detection and Face Recognition.
We’ve released the following projects with the ESP32-CAM: